North
West REPEATERS
VK7RAC --- LOCATED TABLE
CAPE, WYNYARD
TX - 438.650mhz
RX - 433.650mhz
Normally links to Mt Barrow repeater 147.000mhz (-600khz RX) (default
mode) Near Launceston
Mt Barrow is linked to VK7RWC repeater 147.075 (+600khz and 123hz tone
RX) Mt Read near Rosebery
and will be linked to soon to be
installed VK7RAL repeater 439.900mhz (-5Mhz 141.3hz tone RX)
Companion Hill, 35k SSW of Burnie.
LINK OPTIONS
Link is switchable with DTMF tones
DTMF A31 for
linking disable - VK7RAC only
DTMF A32
for linking VK7RAC only to Mt
Duncan repeater 438.600mhz. VK7RAA switches off.
DTMF A36 for linking
to Mt Duncan repeater 438.600mhz and Mt Barrow repeater
147.000mhz
Linking returns to default state after 60 seconds idle time, or
DTMF tones A35
When a change of linking is activated there is a reverse tail beep
burst on all
activated radios to indicate that linking did occur. This allows remote
users to know
the link status did change. Unlinked radios do not get any indication.
Tail beep sequence for change of link mode -
VK7RAC only (A31) - no beep
VK7RAC and VK7RMD (A32) - 2 beeps with short gap ( like morse code M )
VK7RAC and VK7RAA (A35) - 2 beeps with large gap ( like morse code T T )
VK7RAC VK7RMD and VK7RAA (A36) - 3 beeps with short gap
VK7RMD --- LOCATED ON MT DUNCAN, DIAL RANGE, SOUTH OF
PENGUIN
TX - 146.625mhz
RX - 146.025mhz
TX - 438.600mhz -- Links to
Table Cape as per above details
RX - 433.600mhz with 141.3hz access tone
VK7RNW --- LOCATED AT LONAH, ON COAST BETWEEN PENGUIN AND
ULVERSTONE
TX - 146.750mhz
RX - 146.150mhz
CCARC Repeaters
View Larger Map
West coast coverage
VK7RAL and VK7RWC